|
Here is an e-book on how to use HDR from inventor Steven L. Gibbs, but most of my time I will focus on using my Steven Gibbs Hyper Dimensional Resonator – HDR for astral time travel to the alternate time line futures. |
| These dips are probably harmonic waves. What they are we are not sure. The wall outlet supplies 120Volt AC at 60 hertz in a sine wave. Steven Gibbs says a power inverter sometimes uses a square wave. Well, this give us richer harmonics, but it feels like a kind of dirty power. Personally, I prefer the sine wave. However, power inverters that can generate a pure sine wave are very expensive. That is why I use my Radio Shack one. It was only $60 on sale and that is good enough for me. |  |
|
|
Scalar
waves appear to enhance etheric energy that is used by psychics. They
resonate along a multidimensional axis, thus we have a hyper
dimensional resonator. By changing the frequency of the scalar waves
that we generate we can determine where and when we land. The
frequency is altered using the two knobs. Actually, one problem that I have with the HDR, is that I will be slightly off target, like I aim for the year 1915 and land on 1916. This is because I did not tune the knobs correctly. You can also go back far into the past and see the pyramids being built or the statues on Easter Island. |
Witness Well
To
get an accurate fix on my target, I will often place an item in the
witness well, like for example, a picture taken in the 1920's of
Coney Island. So I can go back to the time of jazz and Model T-Fords.
However, if I wish to go to the future, I can draw a picture on a
piece of paper and place that inside the witness well of the HDR. For
example, a drawing of the Shire Tower in New Chicago in 2150, a city
built after the war.
Rubbing Plate
I
will state the question “take me to the Shire Tower in New
Chicago 2150” then stroke the rubbing plate of the of HDR. All
the while turning the knobs to find the proper frequency. When my
fingers get stuck to the plate like glue, then I can power up the
electromagnet. I will let the magnet ride for about seven mins. If it
goes much over ten minutes the electromagnet will get hot.
Barium Oxide Bar
Magnet
The Barium Oxide Bar Magnet is used to boost the power of the HDR
electromagnet so that my astral body has more energy. This is a great way to
increase the ability of the astral traveler. With a bar magnet my ability is far
greater than with just an electromagnet.
Time Coils
By placing curly cords called “Time Coils” around my head
the frequency is established. The
time coil is supposed to help make my finding the proper frequency
easier. They are supposed to interact with my astral soul.
Quartz Crystal
I
believe that a double terminated quartz crystal helps me focus on the
time I wish to travel to. For example, if I want to see how things
are going to be next year, I can focus on what I wish to see. The
problem is that there is a big war in the future and many important
landmarks are gone.
Grid Point Vortex
According to Steven Gibbs,
the Hyper Dimensional Resonator works best when it is over a grid
point vortex. Although you can create an artificial grid point using
two copper pipes, a natural grid point is supposed to be better.
To find a grid point I use
a EMF detector also known as a gaussmeter. This device is often used
by ghost hunters because paranormal events tend to occur near a
vortex. My EMF meter measures the strength of magnetic fields and
basically, I am looking for an anomaly – an area where the
electromagnetic fields are stronger than normal.
A grid point forms where two
grid lines cross. See more on this in the Hartmann Grid. if a grid
point is very powerful it is called a vortex. It is like a magnetic
tornado. This is a place where the fabric of space time is weak and
time travel is supposed to be easier.
A cheap way to hunt for a vortex is to use a compass. If the needle spins line a top, then you are over a vortex. This is an ideal place to use the HDR. My best results are on the morning of a full moon.
